Oil Pan

Heaters

Fuel Filter

Heaters

Battery

Warmers

Popular Items

  • DPP_0005
    uncategorized

    THB60-2

    • Output Power : 60
    • Amps : 0.25
    • Voltage : 240
    • Power Source : AC
    • Distributors : N/A
    • Weight (lbs) : 0.5
    • Width (inches) : 5.5
    • Height (inches) : 8.5

    Cold temperatures dramatically reduce the effectiveness of the chemical reactions within the battery while increasing the battery’s internal resistance; these factors cause a reduction in cranking power of the battery as the temperature drops.

    Batteries left in a discharged state can freeze and cause damage in cold temperatures.

    (0 reviews)
    $53.95 Add to cart
  • HS3comp
    uncategorized

    HS-3

    • Amps : 15
    • Voltage : 120
    • Power Source : AC
    • Weight (lbs) : 0.25
    • Width (inches) : 3.25
    • Height (inches) : 1.25
    • Depth (inches) : 1

    The HS-3 Heater-Stat is an temperature controlled electrical thermostat outlet. Designed to automatically turn electrical devices on and off  when the ambient temperature drops or raises in accordance with a preset temperature setting; the HS-3 is the ideal device to control the operation of the Oil Pan Heater and Battery Warmer or Block Heater.

    The HS-3 plugs into an outdoor 120 volt AC electrical outlet and has two 120 volt receptacles. The maximum electrical load is 1800 watts; this will accommodate both the largest oil pan heater, TH1000-1, and  the battery warmer, TBH60-1, being plugged in together.

    The oil pan heater and the battery warmer will be automatically turned on when the ambient temperature falls below 35°F (2°C) and stay on and until the ambient temperature exceeds 45°F (7°C).

    (0 reviews)
    $21.00 Add to cart
  • uncategorized

    TH250-1

    • Output Power : 250
    • Amps : 2.2
    • Voltage : 120
    • Power Source : AC
    • Gas Engine Capacity : 5-12 US Quarts
    • Diesel Engine Capacity : 5-14 US Quarts
    • Auto/Manual Transmission : N/A
    • Hydraulic Tank Capacity : 40-120 US Quarts
    • Water Tank Capacity : 100-180 US Quarts
    • Weight (lbs) : 0.75
    • Width (inches) : 3.5
    • Height (inches) : 4.5

    TITAN Pad Heaters are 0.075″ (1.9mm) thin flexible silicone oil pan heating pads that are attached to the outside of an oil pan or metal fluid reservoir such as a hydraulic tank. The pad incorporates a 3M peel back adhesive on one side that bonds onto the metal surface. Once installed, the heater pad will never fall off.

    An engine oil pan heater is far superior to a block heater and more efficient as a block heater only “warms” a part of the engine not all the engine.

    An engine oil pan heater, “heats” the complete engine starting at the bottom; the hot oil heats the crankshaft, which in turn heats the connecting rods, pistons and cylinder heads.

    TITAN oil pan heaters are supplied with an installation kit and instructions for a complete installation; no special tools or skills are required.

    Remember, heat rises up!

    (0 reviews)
    $69.95 Add to cart
  • uncategorized

    TH250-1KIT

    • Output Power : 250
    • Amps : 2.2
    • Voltage : 120
    • Power Source : AC
    • Gas Engine Capacity : 5-12 US Quarts
    • Diesel Engine Capacity : 5-14 US Quarts
    • Auto/Manual Transmission : N/A
    • Hydraulic Tank Capacity : 40-120 US Quarts
    • Water Tank Capacity : 100-180 US Quarts
    • Weight (lbs) : 1.5
    • Width (inches) : 4
    • Height (inches) : 5

    A start-up heater kit provides the ideal three basic components to ensure optimum heating under cold conditions. The kit consists of a TITAN TH250-1 Oil Pad Heater, a TITAN THB60-1 Battery Warmer together with a HS3 Thermostat.

    TITAN Pad Heaters are 0.075″ (1.9mm) thin flexible silicone oil pan heating pads that are attached to the outside of an oil pan or metal fluid reservoir such as a hydraulic tank. The pad incorporates a 3M peel back adhesive on one side that bonds onto the metal surface. Once installed, the heater pad will never fall off.

    An engine oil pan heater is far superior to a block heater and more efficient as a block heater only “warms” a part of the engine not all the engine.

    An engine oil pan heater, “heats” the complete engine starting at the bottom; the hot oil heats the crankshaft, which in turn heats the connecting rods, pistons and cylinder heads.

    TITAN oil pan heaters are supplied with an installation kit and instructions for a complete installation; no special tools or skills are required.

    Remember, heat rises up!

    (0 reviews)
    $135.00 Add to cart
  • TH250-2
    uncategorized

    TH250-2

    • Output Power : 250
    • Amps : 1.1
    • Voltage : 240
    • Power Source : AC
    • Gas Engine Capacity : 5-12 US Quarts
    • Diesel Engine Capacity : 5-14 US Quarts
    • Auto/Manual Transmission : N/A
    • Hydraulic Tank Capacity : 40-120 US Quarts
    • Water Tank Capacity : 100-180 US Quarts
    • Weight (lbs) : 0.75
    • Width (inches) : 3.5
    • Height (inches) : 4.5

    TITAN Pad Heaters are 0.075″ (1.9mm) thin flexible silicone oil pan heating pads that are attached to the outside of an oil pan or metal fluid reservoir such as a hydraulic tank. The pad incorporates a 3M peel back adhesive on one side that bonds onto the metal surface. Once installed, the heater pad will never fall off.

    An engine oil pan heater is far superior to a block heater and more efficient as a block heater only “warms” a part of the engine not all the engine.

    An engine oil pan heater, “heats” the complete engine starting at the bottom; the hot oil heats the crankshaft, which in turn heats the connecting rods, pistons and cylinder heads.

    TITAN oil pan heaters are supplied with an installation kit and instructions for a complete installation; no special tools or skills are required.

    Remember, heat rises up!

    (0 reviews)
    $73.95 Add to cart
  • TH250-12
    uncategorized

    TH250-12

    • Output Power : 250
    • Amps : 20
    • Voltage : 12
    • Power Source : DC
    • Gas Engine Capacity : 5-12 US Quarts
    • Diesel Engine Capacity : 5-14 US Quarts
    • Auto/Manual Transmission : N/A
    • Hydraulic Tank Capacity : 40-120 US Quarts
    • Water Tank Capacity : 100-180 US Quarts
    • Weight (lbs) : 0.5
    • Width (inches) : 5
    • Height (inches) : 5

    TITAN Pad Heaters are 0.075″ (1.9mm) thin flexible silicone oil pan heating pads that are attached to the outside of an oil pan or metal fluid reservoir such as a hydraulic tank. The pad incorporates a 3M peel back adhesive on one side that bonds onto the metal surface. Once installed, the heater pad will never fall off.

    An engine oil pan heater is far superior to a block heater and more efficient as a block heater only “warms” a part of the engine not all the engine.

    An engine oil pan heater, “heats” the complete engine starting at the bottom; the hot oil heats the crankshaft, which in turn heats the connecting rods, pistons and cylinder heads.

    TITAN oil pan heaters are supplied with an installation kit and instructions for a complete installation; no special tools or skills are required.

    Remember, heat rises up!

    (0 reviews)
    $89.95 Add to cart

About Titan Pad Heaters

Titan Heaters has been supplying engine oil pan heaters worldwide over 30
years. Our Pad Heaters are made in America and have an excellent build quality.

Indeed, our heating solutions for engines, transmissions, hydraulics and water tanks
are known for their durability. Titan Heaters Pad Heaters sold with a lifetime
warranty so there is no need to worry about it failing after a few cold winters.

We have over 200
Certified Partners

Save-100$

Save up to $100

Free Delivery

Worldwide from $75

Easy returns

365 days for free returns

Comfort Payments

Credit Cards Available

Free Gifts

Get gifts and discounts